"Teaching reference","Example change","Expected action","What to check","MEP revision","Host ID","Link/source ID","Coordination ID before","Coordination ID after","Revit ID before","Revit ID after","Dimensions before and unit","Dimensions after and unit","Observed action","Result and Notes","Evidence section or CSV","Use" "WP-A","The straight pipe grows from 4 to 6 inches outside diameter. The wall, link instance, source element and opening family stay the same.","Update","Check the proposed dimensions in section. If you apply the compatible update, the coordination ID and Revit element ID should both persist.","","","","","","","","","","","","","External worksheet; do not import. References and sizes are illustrative. Fill in actual model data." "WP-B","For another tracked rectangular opening, the Wall Rectangular mapping proposes a different valid family. WP-A keeps its Wall Round mapping.","Replace","Check the family and dependent tags. Leave it unchecked for the first apply. If an in-place change is unavailable and recreation would delete dependencies, the row should fail and roll back.","","","","","","","","","","","","","" "WP-C","A duct no longer crosses its original wall, and the source and host were successfully scanned in the intended scope.","Orphan","Inspect the previous opening and record a separate decision. Orphan is review only; the plug-in does not automatically delete the opening.","","","","","","","","","","","","","" "WP-D","In a separate coverage check, the copy’s link is unloaded or outside the scan scope.","No orphan diagnosis","Do not infer an orphan from missing results. Restore coverage and scan again before deciding.","","","","","","","","","","","","",""